Multiple Choice
Identify the
letter of the choice that best completes the statement or answers the question.
|
|
|
1.
|
The
thread class that would be used when close tolerances are required is ____.
|
|
|
2.
|
The
quality of some fasteners can be determined by the ____ on the head of a bolt or
screw. a. | number of
grooves cut | c. | length of the
lines | b. | number of sides | d. | grade markings | | | | |
|
|
|
3.
|
The
type of bolt that is threaded over its entire length is called a ____. a. | machine
bolt | c. | cap
bolt | b. | stud
bolt | d. | socket head
bolt | | | | |
|
|
|
4.
|
The
purpose of a jam nut is to ____. a. | hold a piece of material
stationary | c. | stop rotation of
a machine quickly for safety reasons | b. | lock a standard nut in place | d. | compress a lock washer in place | | | | |
|
|
|
5.
|
The
type of nut that is used to prevent contact with sharp edges of threads on a fastener is the ____
nut. a. | castellated | c. | self-locking | b. | jam | d. | acorn | | | | |
|
|
|
6.
|
Washers are used to ___. a. | distribute the load over a large
area | c. | anchor materials
that expand due to temperature changes | b. | attach an item to a hollow
surface | d. | allow the bolts
to expand with temperature change | | | | |
|
|
|
7.
|
torque is normally expressed in ____. a. | pounds per
square inch (psi) | c. | foot pounds (ft
lbs) | b. | gallons per
minute (GPM) | d. | cubic feet per
minute (cpm) | | | | |
|
|
|
8.
|
The
fastener that is used to keep a gear of pulley from rotation on a shaft is the ____. a. | key | c. | throw
bolt | b. | retaining
ring | d. | safety
wire | | | | |
|
|
|
9.
|
What
type of fasteners are commonly used as lifting devices? a. | Toggle
bolts | c. | J-bolts | b. | Anchor bolts | d. | Eye bolts | | | | |
|
|
|
10.
|
Wedge
and sleeve anchors are classified as ____ anchors. a. | bolt | c. | one-step | b. | hollow-wall | d. | screw | | | | |
|